Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
197/346
6.4.2
VSD
This menu shows parameters from the connected frequency converter.
Note:
The VSD menu will only be visible if
Drive Com
is set to
LS
or
DA
, see subsection
6.4.1 Drive - 7:
Drive Com
for further information.
For the
Danfoss
(DA) frequency drive (e.g. SABflex) the VSD menu includes only the drive alarm word
information found in VSD sub menu 16-19*:
The Danfoss VSD menus intended for drive commissioning are not available from the UniSAB III VSD
menu but only with the Danfoss drive interface unit mounted in the drive front.
For further explanation on this drive alarm information, please refer to the Danfoss frequency drive
manual.
For the
Leroy Somer
(LS) frequency drive (SABCube 109 – 159) the VSD menu includes the approxi-
mate 530 set-up parameters available for the SABCube Leroy Somer frequency drive.
The VSD menu system is build up into 22 sub-menus. As these sub-menus are intended for drive com-
missioning, they are only available in English.
Warning!
Only authorised personal is allowed to service the frequency drive and to change the VSD parameter
settings. It is also very important that you comply with the drive safety regulations. Failure to do so may
cause damage to equipment and affect personal safety.
Summary of Contents for SABROE Unisab III Control
Page 1: ...UniSAB III control Version 1 10 8 Engineering manual EN...
Page 2: ......
Page 347: ......
