Johnson Controls PENN ACT2, Technical Bulletin, Page: 66 / 116

Maestro Software
66
Unit #3 System Setup
System Setpoints
Time:
Date:
hh:mm [24-hour]
mm/dd/yy
Site Name
Time Setup
HVAC Log interval [Min]: 0
0
Start
00/00/00
Point:
Stop
00/00/00
Year 1:
Daylight Saving Time:
00/00/00
Year 2:
Phone numbers to dial
Modem initialization string
Schedule
0
1
0
0
2
Dial out delay minutes
00/00/00
None
Outside temperature
Board:
Save
Send if Online
Send if Online
Site Name: This identifies the location of a controller
or network of controllers. Site names can be up to 19
characters long.
Time Setup: This section sets the clock to the
correct date and time. Time must be given in the
24-hour format (e.g., 6:00 p.m. should be given
as 18:00.)
HVAC Log Interval: This gives the frequency (in
minutes) at which the HVAC status parameters
(outdoor temperature, zone temperatures, and zone
humidities) are logged.
Outside Temperature: This defines the I/O board
location of the outside air temperature sensor input.
Modem Initialization String: This line is used to
send specialized commands to the modem, such as
specifying after which ring the modem will answer.
Phone Numbers to Dial: This defines a primary
and secondary phone number for the modem to dial
according to
when an alarm condition is detected.
the schedule defined to the right or
Dial Out Delay: This is the number of minutes after
an alarm condition is sensed that the controller
delays dialing the phone numbers entered above.
Daylight Saving Time: This section
defines the dates to begin and end the
time shift for daylight saving time for the
next two years.
Save: Clicking on the Save button downloads the
system information to the controller if your
connection is either direct or online. If you are
working offline, the information is saved to the
folder on the hard drive that contains this
controller's information.
Figure 61: System Setup Screen