This section explains how to use the ADJUST command to change the
value of an Analog Data object, and how to adjust an Analog Output
Setpoint. You will also learn how to use the Network Terminal to adjust
the setpoint, binary, and multistate attributes within Control System
objects.
Note:
AOS objects eligible for local control cannot be adjusted.
The value entered with the ADJUST command stays in effect until a new
value is entered.
To adjust an AOS, AD, PIDL, CS, or L2 object:
Adjusting AOS,
AD, or CS
Objects
1. Select the system and the object.
Note:
In order to command an attribute within a CS object, the desired
attribute must first be specified using DDL or the CS object
Definition window.
2. Select the ADJUST command.
3. If the value is analog, enter the new value. If the object is binary or
multistate, select the desired state.
4. Select
EXECUTE.
5. Press
ENTER.
42
Network Terminal User’s Manual
