5724452-UIM-A-0619
Johnson Controls Ducted Systems
19
SECTION XV: START UP SHEET
Residential Air Handler
with Electric Heat Start-Up Sheet
Proper start-up is critical to customer comfort and equipment longevity
Other Jumpers
(Check all that apply)
Equipment Data
Blower Type
&
Set-Up
A
B
C
D
A
B
C
D
Total external static pressure
Supply
Return
Condensate drain properly connected per the installation instructions
Condensate trap has been primed with water
Duct connections are complete:
Number of filters
Filter size
Unit is level
Filters installed
Retrofit
New Construction
Down flow
Up flow
Horizontal Left
Horizontal Right
Ground connected
Start-Up Technician
Company Name
208 volts AC
230 volt AC
Line Voltage Measured (Volts AC)
Supply static (inches of water column)
Supply air dry bulb temperature
Return air dry bulb temperature
Temperature drop
1
2
3
4
5
Low
Medium Low
Medium
Medium High
High
A
B
C
D
Outside air dry bulb temperature
Return air wet bulb temperature
Supply air wet bulb temperature
Return static (inches of water column)
Electrical Connections & Inspection
(Complete all that apply)
Continued on next Page
ECM
X-13
PSC
A
B
C
D
Low voltage value between "R" and "C" at control board (Volts AC)
Thermostat wiring is complete
Thermostat cycle rate or heat anticipator adjusted to Installation Manual specifications
AC
HP
M
L
H
NO
YES
Equipment Data
Air Flow Setup
COOL
ADJUST
DELAY
HEAT
HUM STAT
AC/HP
CONT FAN
Name
Address
City
State or Province
Zip or Postal Code
Daytime Phone
Unit Model #
Unit Serial #
Transformer wired properly for primary supply voltage
Inspect wires and electrical connections
Unit Location and Connections
(Check all that apply)
General Information
(Check all that apply)
Start-Up Date
Filters
Owner Information
Print Form
Reset Form
