VFD keypad
The VFD requires a keypad to program the VFD. The keypad is not required to operate the unit
when the VFD is programmed. The keypad is required during initial startup of the unit. Each
unit comes with a factory installed and programmed remote keypad and short Ethernet clip on
connector. An Ethernet communication cable is supplied by the factory. You can use a single keypad
to program multiple units. Consult with your sales office to order additional keypads. A copy of the
factory default settings is saved to the keypad memory available for restore if needed.
To clone a VFD on another unit, refer to the upload/download procedure in the
ACS320 drives User
Manual
(pg.72-74). ABB Code 3AUA0000062599.
Figure 3: VFD keypad
VFD for D-Series (DSV/DSH) Air-cooled Self-Contained Units, and C-Series (CSV) Water-Cooled Self-Contained Units,
C-Gen
12
Johnson Controls
