Installation Instructions CD-W00-00-0
Issue Date 0501
© 2001 Johnson Controls, Inc.
1
Part No. 24-09601-19, Rev. —
www.johnsoncontrols.com
CD-W00-00-0
Wall Mount CO
2
Transmitter
Application Requirements
FCC Compliance Statement
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference at
his/her own expense.
Canadian Compliance Statement
This digital apparatus does not exceed the Class A
limits for radio noise emissions from digital
apparatus set out in the Radio Interference
Regulations of the Canadian Department of
Communications.
Installation
IMPORTANT:
The CD-W00-00-0 transmitters
are intended to provide input to equipment under
normal operating conditions. Where failure or
malfunction of the transmitter could lead to an
abnormal operating condition that could cause
personal injury or damage to the equipment or other
property, other devices (limit or safety controls) or
systems (alarm or supervisory) intended to warn of,
or protect against, failure or malfunction of the
transmitter must be incorporated into and maintained
as part of the control system.
Parts Included
•
Wall Mount Carbon Dioxide (CO
2
) Transmitter:
base, PCB, and cover (see Figure 1)
•
Drywall Spring-Clip Mounting Kit (includes two
each No. 6-20 x 1.25 in. pan-head,
self-tapping screws, spring clips, and spacers)
Mounting
The CO
2
transmitter is shipped with parts separated,
ready for standard wallbox or surface mounting with
the Drywall Spring Clip Mounting Kit (included).
IMPORTANT:
Avoid touching or applying force
to the components on the Printed Circuit Board
(PCB). Handle the board by the edges only.
Location Considerations
This device mounts either on a U.S. wall box or
directly to a wall surface.
Locate the transmitter on an inside wall, free from
drafts, and out of direct sunlight. The device is shock
and vibration resistant; however, be careful not to drop
the unit or to mount it where it could be exposed to
excessive vibration. The following ambient operating
conditions apply:
•
Temperature: 23 to 113
°
F (–5 to 45
°
C)
•
Humidity: 0 to 85% Relative Humidity (RH),
non-condensing 85
°
F (29
°
C) maximum dew
point
Base
Center
Hole
Cover
PCB
Figure 1: Mounting the Transmitter
