Cruisecontrol GC90 installation manual
12
4.2
Accelerator pedal set-up
Perform the following steps to learn the GC90 to the accelerator pedal.
Perform step 1-6 within 1 minute!
Step
Action
Confirmation
1
switch the ignition OFF and ON (do not start!)
2
Switch the Cruisecontrol on
2 low beeps
3
Press and hold the brake pedal during the next 2 steps.
4
Operate 4 times
4 beeps
5
Operate once
1 beep
6
Release the brake pedal
1 beep
7
Operate once
1 beep
8
Gently press the accelerator to full throttle
beeps pulsating low
9
Operate once
10
release the accelerator pedal
11
Press and hold the brake pedal and operate 4 times
beeps stop
1 long beep
12
Release the brake pedal.
i
Some accelerator pedals do not have consistent signal values near the full
travel area (presence of a full throttle switch). Therefore the pedal set-up
may fail.
If at step 9 the beep pulsates high/low the pedal set-up failed.
In this case repeat the pedal set-up, but only press the accelerator pedal to
95% of its full travel at step 8.
