Cruisecontrol GC90 installation manual
9
3.3
T-harness connection
Undo the negative battery terminal before working on the vehicle.
Loss of volatile data is possible (audio, board computer, clock, etcetera).
As the T-harness is vehicle specific, it is supplied as a separate component.
Read the accompanying installation manual carefully.
Connect the T-harness as follows:
Connect the 8-pin black connector of the T-harness to the 8-pin connector on the
EM;
Undo the accelerator pedal connector and connect it to the T-harness;
Connect the T-harness connector to the accelerator pedal.
3.4
Wiring harness connections
Always use a multimeter when measuring on the vehicle.
Cut wires to size, keep them as short as possible.
Connect the universal wiring harness as follows:
orange
wire
connect to an ignition switched feed (+15), preferably directly after the
ignition switch;
i
For many European car-makes it is possible to connect the orange wire to
the feed wire of the brake lights (along with the brown/white wire).
This is only possible in case the brake lights only operate when the ignition
is switched ON.
brown wire
connect to the wire that is connected to ground via the brake
lights, this becomes 12V when the brake pedal is depressed.
In case a relay is used in the brake light system, connect to the wire that is
connected to the brake lights directly;
brown/
white wire
connect to the fused feed wire of the brake lights, before the
brake light switch;
