John Bean B 200, Operator'S Manual

Page: 82 / 128

82
5-49
5-50
5-51
5-52
Operation
Reading of error code E9
If E9 is read out, at least one error was made with respect
to the sequence of operations when performing optimisation
(
F
7.1 System messages).
—
Abort the optimisation program by pressing the STOP
key and, if desired, start optimisation once again.
Fig. 5-49 OPTIMISATION “ OP.12 ”
(4th measuring run of tyre/rim assembly)
—
Clamp the wheel on the balancer.
—
Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
—
Confi rm the valve position by pressing menu key F1 .
The OPTIMISATION “OP.13” screen (
Fig. 5-50
) is displayed.
Fig. 5-50
OPTIMISATION “
OP.13
”
START is displayed on the screen.
—
Press the START key.
A measuring run is performed.
The
BALANCING screen
( Fig. 5-51 ) is displayed.
Finish weight minimisation / optimisation
Fig. 5-51
BALANCING
If the wheel running conditions are optimal, the following
codes can be displayed
(
Fig. 5-52
):
H0 Wheel running conditions cannot be improved by
optimisation.
H1 Further optimisation not recommended but feasible.
H2 Weight minimisation is recommended, optimisation can
achieve no further improvement.
..