5
USING THE IR-WMR WITH A JOBSITE
M-4KP KEYPAD
The IR-WMR is fully compatible with the JobSite
M-4KP Keypad: follow the wiring instructions in
Figure 3.
OPERATION
Operation of the IR-WMR is simple. Stand within the
operational range of your IR-WMR. Aim your hand-
held remote at the IR-WMR and press the button for
the desired command. Your IR command is instantly
repeated to your A/V equipment.
Green “Power Status” LED
When the IR-WMR is correctly connected, the Green
LED will stay lit as long as the preamp/receiver is on.
When your preamp/receiver is off, the LED will stay off.
Blue “Talkback” LED
The blue “talkback” LED on the IR-WMR visually
confirms the reception of an IR command.
TROUBLESHOOTING
1. Test the remote control(s) by operating the A/V
equipment directly. Replace the batteries if
needed.
2. Double-check the cable connections on all IR-
WMR’s and on the Connecting Block. Look for
open, shorted or reversed wires.
Suggested wiring of WMR to a RJ45 connector
for connection to a JobSite M-4KP keypad.
Figure 3