Joab EcoDrive, Operation And Maintenance Manual

Page: 64 / 73

Threads Torque 8.8 Torque 10,9
M8 24 Nm 33 Nm
M10 47 Nm 65 Nm
M12 81 Nm 114 Nm
M14 128 Nm 181 Nm
M16 197 Nm 277 Nm
M18 275 Nm 386 Nm
M20 385 Nm 541 Nm
M24 518 Nm 935 Nm
Table 10: Torque values for fasteners
Working on the Hook-Lift
Before working on a raised hook-lift, remove the body from the hook-lift. The tip-sup-
port, as described below, must also be in place to support the hook-lift. Failure to do
so, can lead to serious injury or death.
The hook-lift is equipped with a tip-support, as
shown opposite. This must be used when work-
ing on the hook-lift. It supports the hook-lift
when it is raised and acts as a safety measure
in the event of a hydraulic failure.
Shown opposite is the location for storing the
tip-support (shown in red). It is stored on the
right underside of the sub-frame.
The correct placement of the tip-support when
working on the hook-lift is also shown. It must
placed between the sub frame and the inter-
mediate-section, using its anchor points, as
shown and described below.
56
Service and Maintenance | Working on the Hook-Lift
EcoDrive manual: 13300 Edition 1 | 2019-01-31