background image

Skan 1.0
Battery charger 

JM-No. 609 01 96

EN

 Battery charger

PL

 Ładowarka do akumulatorów

ES

 Cargador de baterías

IT

 Caricatore batteria

CZ

 Nabíječka baterií

Thank you very much for choosing a JMP Skan battery charger. The JMP Skan 1.0 charger is suitable for both daily 

use involving rapid charging of a battery and long-term trickle charging (e.g. where vehicles are in winter storage). 

Technical data:

6/12 V 1 A, for batteries from 2 Ah to 50 Ah

Dimensions: 180 x 80 x 40 mm, weight: 0.5 kg, mains power cable: 2 m, connection cable: 2.10 m

Suitable for:

•  Standard lead acid

•  Gel

•  AGM

•  EFB

•  Lithium (LiFePO4)

Safety instructions:

•  Read the operating instructions carefully prior to using the charger.

•  The charger is intended for charging lead acid, gel, AGM, EFB and lithium (LiFePO4) batteries. It should not 

be used for any other purposes.

•  Disposable batteries should not be charged. Do not charge any frozen batteries.

•  Battery acid is caustic. In the event of unintentional contact between the skin or eyes and acid, rinse the skin 

off and the eyes out immediately under flowing water and consult a doctor.

•  Always wear protective goggles when connecting and disconnecting the battery and keep the battery away 

from the face.

•  Keep out of reach of children. This device is not a toy and should not be used as such.

•  This device should not be used by persons (including children) with limited physical, sensory or mental apti-

tude or lacking in adequate knowledge and experience if these persons are not being supervised or have not 

received comprehensive instruction.

•  Potentially explosive gases can be created during charging. Sparking and naked flames should be avoided as 

a result. Do not smoke.

•  Realise charging in a ventilated and dry environment.

•  Never deposit the charger on the battery during charging.

•  Interventions in the device for the purpose of repair and maintenance should only be undertaken by skilled 

personnel.

•  No warranty claims will be entertained in the event of improper use of or interventions in the device.

Scope of delivery:

JMP Skan 1.0, adapter cable with terminals, adap-
ter cable with eyelets for permanent connection to 
the battery

Summary of Contents for Skan 1.0

Page 1: ...tween the skin or eyes and acid rinse the skin off and the eyes out immediately under flowing water and consult a doctor Always wear protective goggles when connecting and disconnecting the battery and keep the battery away from the face Keep out of reach of children This device is not a toy and should not be used as such This device should not be used by persons including children with limited ph...

Page 2: ...r power supply unit to the socket 2 First connect the red terminal to the positive terminal on the battery 3 Then connect the black terminal to either the negative terminal on the battery or the earth terminal on the vehicle body 4 Select the desired charging mode based on the battery using the selection button Then acknow ledge with the start button It is recommended that the optional eyelets be ...

Page 3: ...y and restart charging see Charger use Battery voltage too high attempt to charge a 24 V battery Check battery voltage range Battery charge capacity too high Use a charger with a greater charge capacity Battery is incapable of retaining a good charge level Battery may be faulty Heavily discharged battery is not rechargeable Battery may be faulty Battery voltage too weak not rechargeable Charging o...

Page 4: ...ant current Charging with constant current until maximum battery voltage is achieved 5 Fourth charging step Absorption Charge charge with constant voltage Charging with stabilised voltage until current reaches minimum values 6 Second diagnostic step Diagnostic II second diagnosis The charger checks the status of the charged battery 7 Sixth charging step Float Mode trickle charging with constant vo...

Reviews: