JLG TOUCAN 10E, Operation And Safety Manual, Page: 99 / 130

SECTION 6 – GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
31210088 – JLG Lift – 6-29
6.14 DTC CHECK TABLES
0-0 Help Comments
DTC FAULT MESSAGE DESCRIPTION CHECK
001
EVERYTHING OK The normal help message in Platform Mode. Dis-
plays on the analyzer only.
002
GROUND MODE OK The normal help message in Ground Mode. Dis-
plays on the analyzer only.
008
FUNCTIONS LOCKED OUT -
SYSTEM POWERED DOWN After 2 hours without activity, the Control System
enters a low-power state to preserve battery
charge. Displays on the analyzer only; the MDI’s
LED is blinking with the display Off. • Normal operation should resume after a power cycle.
Refer problem to a qualified JLG mechanic.
0010
RUNNING AT CUTBACK - OUT
OF TRANSPORT POSITION Drive speed is limited while the mast is elevated.
Displays on the analyzer only. • Fully stow the platform.
• Check that the mast switches are securely mounted.
Refer problem to a qualified JLG mechanic.
0022
DIFFERENT FUNCTION
SELECTED & IGNORED Two hydraulically powered movements simulta-
neously controlled. • Release joysticks and allow to center.
Refer problem to a qualified JLG mechanic.
0023
FUNCTION SELECTED BUT
TRIGGER SWITCH OPEN One of the drive joystick functions was activated,
but the trigger switch was not. • Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
• Check if the trigger switch is damaged.
Refer problem to a qualified JLG mechanic.