JLG TOUCAN 10E, Operation And Safety Manual, Page: 63 / 130

SECTION 4 – MACHINE OPERATION
31210088 – JLG Lift – 4-13
4.10 BATTERY CHARGING
NOTE: Be sure that the machine is parked in a well-ventilated
area before charging begins.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND
GROUNDED OUTLET. DO NOT USE GROUND ADAPTORS OR MODIFY
PLUG. DO NOT TOUCH NON-INSULATED PORTION OF OUTPUT CONNEC-
TOR OR NON-INSULATED BATTERY TERMINAL.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR
IF THE CHARGER HAS RECEIVED A SHARP BLOW, BEEN DROPPED OR
OTHERWISE DAMAGED IN ANY WAY.
ALWAYS DISCONNECT THE AC SUPPLY BEFORE MAKING OR BREAKING
THE (POS/NEG) CONNECTIONS TO THE BATTERY.
DO NOT OPEN OR DISASSEMBLE CHARGER.
NOTE: It is not necessary to charge the battery if the electrolyte
specific gravity has not dropped under 1.240kg/l. Doing
so regularly, will greatly reduce battery life.
The battery charger AC input plug (1) is located on the battery
compartment.
1. Connect the AC input plug (1) to a grounded outlet.
2. When first powered up, the charger will go through a
short LED indicator self-test. The battery charger light’s
on the Ground Control Station will flash in sequence for
two seconds.
3. The batteries are fully charged when the green light on
the battery charger status panel (Ground Control Sta-
tion) is illuminated.
NOTE: If the charger is left plugged in, the charger will automati-
cally restart a complete charge cycle if the batteries volt-
age drops below a minimum voltage or 30 days has
elapsed.