JLG Skytrak 3013, Operation & Safety Manual

Page: 49 / 136

Section 3 - Controls and Indicators
3 - 9 31211476
LSI Override Switch
The LSI override switch ( 1 ) momentarily disables the automatic function cut - out.
• Sliding the locking actuator down, depress and hold the switch up to 60 seconds
while operating joystick to momentarily disable the automatic function cut-out.
When the LSI override switch (
1 ) is depressed, the warning buzzer also sounds
intermittently.
Note: If the LSI override switch ( 1 ) is held longer than 60 seconds, the LSI returns to normal
operation. To override again, the LSI override switch (
1
) must be released, depressed and
held again.
• Release switch to re-enable the automatic function cut - out.
WARNING
TIP OVER HAZARD. Exceeding lift capacity of the telehandler could damage the
equipment and/or cause tip over.
1
ON0160