SECTION 4 - MACHINE OPERATION
31215000
4-11
Platform Rotation
To rotate the platform to the left or right, use the
Platform Rotate control switch to select the direc
-
tion and hold until desired position is reached.
4.7
BOOM
A RED TILT WARNING LIGHT IS LOCATED ON THE CONTROL CONSOLE WHICH LIGHTS
WHEN THE CHASSIS IS ON AN EXCESSIVE SLOPE. DO NOT SWING OR RAISE BOOM
ABOVE HORIZONTAL WHEN LIGHT IS LIT.
DO NOT DEPEND ON TILT ALARM AS A LEVEL INDICATOR FOR THE CHASSIS. TILT
ALARM INDICATES CHASSIS IS ON AN EXCESSIVE SLOPE (3 DEGREE OR GREATER).
CHASSIS MUST BE LEVEL BEFORE SWINGING, OR RAISING BOOM ABOVE HORIZONTAL
OR DRIVING WITH THE BOOM ELEVATED.
TO AVOID TIP OVER IF RED TILT WARNING LIGHTS LIGHT WHEN THE BOOM IS RAISED
ABOVE HORIZONTAL, LOWER PLATFORM TO GROUND LEVEL. THEN REPOSITION MACHINE
SO THAT CHASSIS IS LEVEL BEFORE RAISING BOOM.
TRAVELING WITH BOOM BELOW HORIZONTAL IS PERMITTED ON GRADES AND SIDE
SLOPES SPECIFIED ON SERIAL NAMEPLATE ON THE FRAME.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINERY IF ANY CONTROL LEVER OR
TOGGLE SWITCH CONTROLLING PLATFORM MOVEMENT DOES NOT RETURN TO THE
‘OFF’ OR NEUTRAL POSITION WHEN RELEASED.
TO AVOID A COLLISION AND INJURY IF PLATFORM DOES NOT STOP WHEN A CONTROL
SWITCH OR LEVER IS RELEASED, REMOVE FOOT FROM FOOTSWITCH OR USE EMER
-
GENCY STOP SWITCH TO STOP THE MACHINE.
Swinging the Boom
To swing boom, use Swing control to select
Right or Left direction.
Raising and Lowering the Main Boom
To raise or lower the Main Boom, position Main
Boom Lift switch to Up or Down until desired
height is reached.
To
order
go
to
Discount-Equipment.com
