JLG 680S, Service And Maintenance Manual

Page: 452 / 530

SECTION 6 - JLG CONTROL SYSTEM
6-36 3121234
CALIBRATION DATA
LOAD 500 LB :
CALIBRATION DATA
PLATFORM UP :
FROM
DIAGNOSTICS :
UMS
DIAGNOSTICS :
LOAD
CAPACITY LENGTH
SWITCH : CLOSED
CAPACITY ANGLE
SWITCH : CLOSED
PERCENT OF MAX
LOAD : XXX %
PLATFORM LOAD
STATE : OK
PLATFORM LOAD
ACTUAL : XXXLBS
PLATFORM LOAD
GROSS : XXXLBS
PLATFORM LOAD
OFFSET 1 : XXXLBS
PLATFORM LOAD
OFFSET 2 : XXXLBS
PLATFORM LOAD
UNRSTRICT XXXLBS
PLATFORM LOAD
RSTRICT XXXLBS
PLATFORM LOAD
RAW 1 : XXXLBS
PLATFORM LOAD
RAW 2 :
DIAGNOSTICS :
CAN STATISTICS
CAN STATISTICS
RX /SEC : X
CAN STATISTICS
TX/SEC : X
CAN STATISTICS
BUS OFF : X
CAN STATISTICS
PASSIVE : X
CAN STATISTICS
MSG ERROR
: XXXX
DIAGNOSTICS :
CALIBRATION DATA
CALIBRATION DATA
LOAD ZERO :
1
CALIBRATION DATA
PLATFORM DN :
DIAGNOSTICS :
DATALOG
DATALOG :
ON : XXXh XXm
DATALOG :
ENGINE : XXXh XXm
DATALOG :
DRIVE : XXXh XXm
DATALOG :
LIFT : XXXh XXm
DATALOG :
SWING : XXXh XXm
DATALOG :
TELE : XXXh XXm
DATALOG :
MAX TEMP : XXXF
DATALOG :
MIN TEMP : XXXF
DATALOG :
MAX VOLTS : XX.XV
DATALOG :
RENTAL : XXXh XXm
DATALOG :
ERASE RENTAL ? CLEAR RENTAL :
YES : ENTER ,NO : ESC
DIAGNOSTICS :
VERSIONS
GROUND MODULE
SOFTWARE : XX.XX
GROUND MODULE
COST . DATA : XX.XX
GROUND MODULE
HARDWARE : REV XX
GROUND MODULE
S /N: XXXXXX
PLATFORM MODULE
SOFTWARE : XX .XX
PLATFORM MODULE
HARDWARE : REV XX
PLATFORM MODULE
S /N: XXXXXX
PROPULSION MOD
SOFTWARE : XX .XX
TCU MODULE
SOFTWARE : XX .XX
TCU MODULE
HARDWARE : REV XX
TCU MODULE
S /N : XXXXXX
GATEWAY MODULE
SOFTWARE : XX .XX
GATEWAY MODULE
HARDWARE : REV XX
ANALYZER :
ANALYZER XX .XX
XXXLBS
Figure 6-13. Analyzer Flow Chart Version 6.X Software -Sheet 3 of 9
NOTE: The layout shown includes all possible analyzer screens. Please note that some screens may not be available depending upon
machine configuration and software versions.