JLG 680S, Service And Maintenance Manual

Page: 421 / 530

SECTION 6 - JLG CONTROL SYSTEM
3121234 6-5
Level Vehicle Description
A NEW TILT MODULE WILL ACT AS IF IT IS TILTED ALL OF THE TIME UNTIL THE
FOLLOWING PROCEDURE IS PERFORMED.
DO NOT CALIBRATE THE LEVEL SENSOR EXCEPT ON A LEVEL SURFACE.
Place machine in stowed position with the boom between the
rear wheels.
To level machine chose:
CALIBRATION:
TILT SENSOR
Press ENTER .
When prompted, swing machine 180°
Press ENTER .
Table 6-1. Analyzer Abbreviations
ABBREVIATION MEANING
ACCEL ACCELERATE
ACT ACTIVE
A/D ANALOG DIGITAL CONVERTER COUNT
AMB. AMBIENT
ANG ANGLE
AUX AUXILIARY
BCS BOOM CONTROL SYSTEM
BM BOOM LENGTH ANGLE MODULE
BLAM BOOM LENGTH ANGLE MODULE
BR BROKEN
BSK BASKET
CAL CALIBRATION
CL CLOSED
CM CHASSIS MODULE
CNTL CONTROL
CNTRL CONTROL
C/O CUT OUT
CONT(S) CONTRACTOR(S)
COOR COORDINATED
CRK PT CRACK POINT
CRP CREEP
CUT CUTOUT
CYL CYLINDER
DECEL DECELERATE
D DOWN
DN DOWN
DWN DOWN
DEG. DEGREE
DOS DRIVE ORIENTATION SYSTEM
DRV DRIVE
E ERROR
E&T ELEVATED & TILTED
ELEV ELEVATION
ENG ENGINE
EXT EXTEND
F FRONT
FL FLOW
FNT FRONT
FOR FORWARD
FWD FORWARD
FSW FOOT SWITCH
FUNC FUNCTION
G GROUND