JLG 530LRT, Service And Maintenance Manual

Page: 92 / 262

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-50 3121781
Cover Removal
NOTE: Procedures apply to both left and right side compart-
ment hoods.
1. Elevate the platform to a height where, when
removed and lifted, the compartment covers clear
the underside of the platform. Engage the arm safety
prop and/or block the scissor arms to prevent lower-
ing.
2. Disable machine operation.
3. If removing the main compartment cover, the hinged
cover and any outer covers/doors must be removed
first.
4. Attach lifting straps to each end of the large com-
partment cover and support with an overhead lifting
device.
5. Remove the bolts on the hinges to remove the door
from the cover.
6. Remove the bolts and washers, from the front covers
or doors, remove and lay aside.
7. Remove the ladder from the support bracket by
removing the bolts, washers and nuts.
8. Remove the bolts and washers, from the front, top
and back of the large compartment cover.
NOTE: On engine side only, remove the exhaust pipe shield
from the cover by removing the bolts, washers, and
nuts.
9. Carefully lift the main compartment cover up and
away from the machine.
Cover installation
1. Follow Removal Steps in reverse.
3.10 GROUND CONTROL STATION
Control Station Removal
REMOVAL
1. Disconnect and label the harnesses from the ground
control box (1).
2. Remove the ground control box from the control box
mount (2) by removing the four lower and two upper
bolts, nuts and washers (3).
INSTALLATION
1. Follow Removal Steps in reverse.
3
1
2
3
MAF04200
1. Ground Control Box
2. Control Box Mount 3. Mounting Bolts, Nuts
and Washers
Figure 3-41. Ground Control Station Removal