JLG 530LRT, Service And Maintenance Manual

Page: 77 / 262

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121781 3-35
3.5 AXLE INSTALLATION
Front Axle Assembly (Fixed)
REMOVAL
SUPPORT THE FRAME AND AXLE BEFORE ATTEMPTING ANY REMOVAL
AND/OR ASSEMBLY PROCEDURES.
1. Disable machine operation. Remove wheel and drive
assemblies.
2. Remove the bolt and pin keeper (5).
3. Push the axle pivot pin (1) out and remove the thrust
washer (4) and bearings (3).
4. Front axle (1) can now be moved away from the
frame.
ASSEMBLY
1. When installing the axle assembly, follow Removal
Steps in reverse.
2. Shim both the stop block pad and the wear pad to
achieve a maximum gap of 1/16 in. (1.5 mm)
between the pad and the axle machined surface.
NOTE: Apply Loctite® #242 to bolts (9) attaching stop block
pad (6), and wear pad (12).
1. Front Axle
2. Pivot Pin
3. Pivot Pin Bushing
4. Thrust Washer 5. Pin Keeper and Screw
6. Stop Block Pad
7. Stop Block Shims 8. Stop Block Pad Bracket
9. Hex Head Screws
10. Washers
11. Nuts
12. Wear Pad
13. Wear Pad Shims
Figure 3-28. Axle Assembly (Fixed)
9
13
12
3
2
3
4
5
1
9
10
6
7
8
11
10
9
MAF03740
10
9
10