JLG 530LRT, Service And Maintenance Manual

Page: 75 / 262

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121781 3-33
18. Cover shaft splines with an installation sleeve. Install
a new shaft seal (27) with the cup side facing the
motor. Press seal into housing until it bottoms out.
Press evenly to avoid binding and damaging the seal.
Install seal support washer (28) and snap ring (29).
19. Install remaining plugs and fittings to the housing.
Refer to the drawing below for wrench sizes and
installation torques.
29
28
27
27. Shaft Seal
28. Seal Support Washer
29. Snap Ring
Figure 3-25. Shaft Seal
1/4 in
(45 Nm)
33 ft.lbs.
5/16 in
(85 Nm)
63 ft.lbs.
5/16in
(85 Nm)
63 ft.lbs.
1/4 in
(45 Nm)
33 ft.lbs.
9/16 in
(170 Nm)
125 ft.lbs.
3 mm
(2.03 to 3.39 Nm)
1.5 to 2.5 ft.lbs.
Figure 3-26. Plugs and Fittings Installation