JLG 3507, Supplemental Repair Manual, Page: 42 / 180

40
ASSEMBLY
Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
ASSEMBLY
FIGURE 19: Lubricate the bushing (18) and the seat of the
steering case (3).
Install the bushing (18), using tool T1 (See drawing T1 p. 44).
FIGURE 20: Lubricate the outer surface of the sealing ring
(17) and centering ring (16); fit them into their seat using tool
T2 (See drawing T2 p. 44).
FIGURE 21: Fit the steering case (3) onto the U-joint (19) and
install the articulation pins.
For pin assembly details, see COMPLETE STEERING CASE
p. 25.
T 7
T1
18
3
T8
T2
16 17
19
3
FIGURE 22: Position the lower part of tool T3A (See drawing
T3 p. 45) and the thrust block of the external bearing (8) under
the press.
FIGURE 23: Lubricate the seats of the bearings and position
the hub (7) on tool T3A (See drawing T3 p. 45); position the
thrust block of the internal bearing (15).
NOTE:
Check that the thrust block is correctly oriented.
FIGURE 24: Position the upper part of tool T3B (See drawing
T3 p. 45) and press the thrust blocks into the hub (7) all the
way down.
T9 A
T3A
8
T9 A
T3A
15
T9 B
T3B
7