JLG 340AJ, Service And Maintenance Manual

Page: 335 / 370

SECTION 6 - JLG CONTROL SYSTEM
3121259 – JLG Lift – 6-89
Table 6-16. Overload Variations
BROADCAST ONLY
3
WARN ONLY CUTOUT ALL
SPECIAL 1
(Access Industries)
CUTOUT PLATFORM
Platform
Activate visual overload light at
Platform Station Activate visual overload light at
Platform Station Activate System Distress and Over-
load lights at Platform station Activate visual overload light at
Platform Station Activate System Distress and
Overload lights at Platform sta-
tion
Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– on continuously Activate Platform and Ground
Alarm – 5 sec ON, 2 sec OFF
Do not report Fault Activate creep mode all functions,
energize Creep light, and report
Fault Do not permit Machine Enable (no
creep light) and report Fault Activate creep mode all functions,
energize Creep light, and report
Fault Do not permit Machine Enable
(no creep light) and report Fault
Disable Telescope Out and Lift Up
Ground
Activate visual overload light
(Ground Station) Activate visual overload light
(Ground Station) Activate visual overload light
(Ground Station) Activate visual overload light
(Ground Station) Activate visual Overload light at
Ground Station
Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– 5 sec ON, 2 sec OFF Activate Platform and Ground Alarm
– on continuously Activate Platform and Ground
Alarm – 5 sec ON, 2 sec OFF
Do not report Fault Report Fault Report Fault Do not report Fault Do not report fault.
Activate creep mode all functions Do not permit Machine Enable (no
creep light) Overload shall have no effect on
function speeds. Overload shall have no effect on
function speeds.
Auxiliary Power/Emergency Descent
Platform operation and annuncia-
tion as Platform Mode above Platform operation and annuncia-
tion as Platform Mode above Platform operation and annuncia-
tion as Platform Mode above, except
do not disable all functions Platform operation and annuncia-
tion as Platform Mode above Platform operation and annunci-
ation as Platform Mode above,
except do not report Fault or dis-
able all functions
Ground operation and annunciation
as Ground Mode above, except do
not activate creep mode Ground operation and annunciation
as Ground Mode above, except do
not activate creep mode Ground operation and annunciation
as Ground Mode above, except do
not report Fault or disable all func-
tions Ground operation and annunciation
as Ground Mode above Ground operation and annuncia-
tion as Ground Mode above
Faults
No applicable fault When the platform is overloaded,
report “RUNNING AT CREEP - PLAT-
FORM OVERLOADED.” When the platform is overloaded,
report "DRIVE & BOOM PREVENTED
– PLATFORM OVERLOADED." When the platform is overloaded,
report "LIFT UP & TELE OUT PRE-
VENTED – PLATFORM OVER-
LOADED.” When the platform is overloaded,
report the "DRIVE & BOOM PRE-
VENTED – PLATFORM OVER-
LOADED."
Clarifications:
1. The term Report Fault is defined as logging the DTC on the Analyzer fault stack and flashing the System Distress lamp.
2. When specified, Ground Alarm energization shall only occur if MACHINE SETUP

GROUND ALARM ≠ NO.
3. This selection is not Analyzer configurable in MACHINE SETUP

LOAD SYSTEM but is shown here for completeness of the response table.