SECTION 7 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
31215079
7-5
7.4
DIELECTRIC GREASE APPLICATION
The following is general guidance for the installation of dielec-
tric grease in a connector system.
1.
Use dielectric grease in a tube for larger connection
points or apply with a syringe for small connectors.
2.
Apply dielectric grease to plug/male connector housing
which typically contains sockets contact/female termi-
nals.
3.
Leave a layer of dielectric grease on the mating face of
the connector, completely covering each connector ter-
minal hole. Refer the pictures shown below.
4.
Assemble the connector system immediately to prevent
moisture ingress or dust contamination.
The following connector systems are specifically addressed
because of their widespread use at JLG. However, this guid-
ance may be applied to similar devices
.
AMP Mate-N-Lok
This connector system is widely used inside enclosures for
general-purpose interconnect. Follow the general guidance
for installation.
AMP Faston
This connector system is typically used on operator switches at
JLG. Follow the general guidance for installation.
AMP Micro-Fit
This connector system is typically used on control modules at
JLG. Follow the general guidance for installation.
AMP Mini Fit Jr
This connector system is typically used on control modules at
JLG. Follow the general guidance for installation.
Proper
Improper
Proper
Improper
Proper
Improper
Proper
Improper
Go
to
Discount-Equipment.com
to
order
your
parts