SECTION 2 - GENERAL
3121788
2-9
4. Ensure all downward movement stops when safety
prop is engaged.
To disengage the safety prop:
1.
Raise the platform enough to release the safety
prop.
2.
Push in the safety prop.
3.
Lower the platform to the stowed position.
Hydraulic Oil Check Procedure
(Figure 2-5., and Figure 2-6.)
• Lube Points - Hydraulic Reservoir
• Reservoir Capacity - 4 gal. (15 L)
• Lube - Hydraulic Oil
• Interval - Check Daily
To ensure proper operation of the machine, the hydrau-
lic oil must be checked daily.
NOTE:
Check the hydraulic oil level with the platform in the
stowed position only. Be certain the hydraulic oil
has warmed to operating temperature before
checking the oil level in the reservoir.
1.
Open the hydraulic compartment door and
locate the hydraulic reservoir (1).
2.
Locate the lines indicating the maximum and
minimum levels of hydraulic oil (2 and 3) in the
reservoir. Ensure the level of oil is between the
two lines.
3.
If the level of oil in the reservoir is below the
minimum level (3), more oil is needed. Wipe all
dirt and debris from the filler/filter cap (4) and
surrounding area.
4.
Remove filler cap and add proper grade of oil. Fill
until oil level is close to the maximum level (2).
Do not overfill.
NOTE:
Take precautions so that impurities (dirt, water, etc.)
cannot enter the hydraulic system while filler/filter
cap is removed.
Prop Engaged
Figure 2-3. Scissor Arm - Safety Prop
Prop Disengaged
Figure 2-4. Scissor Arm - Safety Prop
MAF10000
MAF10000
MAF10010
Go to
Discount-Equipment.com
to
order your
parts
