SECTION 5 - OPTIONAL EQUIPMENT
5-6
– JLG Lift –
3121189
Machine Power Up using the PSL™
NOTE:
When entering code on the keypad, a short beep indi-
cates a properly depressed key, a long beep indicates an
error in depressing key. If an error occurs, you must
restart the code entry process again.
1.
Enter the four digit code on the PSL key pad. The
ACCEPT - AMBER LED indicator will be lit if the code is
correct.
2.
Press the keypad ON button. The ON - GREEN LED indi-
cator will light and power will be supplied to the Ground
Control Station.
3.
At the ground control station, turn the main power selec-
tor switch from OFF to ON.
4.
The machine will now operate normally.
Machine Power Down
1.
At the Ground Control Station set the main power selec-
tor switch to the OFF position.
2.
Press the OFF button on the PSL keypad. No LEDs on
the PSL box will be lit.
Changing the Operator’s Code
The PSL Operators Code can be changed by a supervisor should
the need occur. A separate permanent Supervisor’s Code
matched to the serial number of the PSL box is included on a
sheet in the PSL user manual supplied with the machine.
1.
Enter the Supervisor’s code on the key pad. The PRO-
GRAM - RED LED will be lit if correct code is entered.
NOTE:
The ON or OFF button cannot be one of the four digits of
the Operator’s code.
2.
Enter a new four (4) digit Operator’s code on the key-
pad. The ACCEPT - AMBER LED will light up if the new
Operator’s code is accepted.
3.
Press the OFF button on the keypad to activate the new
Operator’s code.
NOTE:
The new Operator’s code will remain in the PSL even
when power is removed from the equipment, or until the
Supervisor changes the Operator’s code.
