JLG 1532R, Operation And Safety Manual

Page: 48 / 98

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-16 – JLG Lift – 3121744
Arm Guards (If Equipped)
If the machine is equipped with electronic arm guards, the plat-
form will stop lowering at a predetermined height and the
machine’s beacons will flash at a different rate to warn ground
personnel, machine lowering can continue after a three (3) sec-
ond delay. Once the lowering function is re-engaged an audible
alarm will sound. After a one and a half (1.5) second delay the
platform will continue lowering.
Overload Indicator (LSS) (If Equipped)
(Item 7)
Indicates the platform has been overloaded.
An audible alarm will also signal when the
platform is overloaded.
NOTE: If the Overload Indicator is illuminated;
CE: All functions will be prevented from the platform and
ground controls. Lower platform using the machine man-
ual descent control.
ANSI Export/Australia/Japan: All platform functions
will be prevented. Fully lower the platform from the
ground controls or using the machine manual descent
control. Reduce the weight in the platform to not exceed
the rated workload indicated on the capacity decal.
Tilt Indicator Warning Light and Alarm
(Item 8)
A red warning light on the control panel illu-
minates and an audible alarm sounds when
the chassis is at or beyond the tilt cutout set-
tings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLAT-
FORM IS RAISED LOWER PLATFORM AND DRIVE TO A SMOOTH FIRM LEVEL
SURFACE.
Horn
(Item 9)
This push-button switch, when pressed, per-
mits the operator to warn job site personnel
when the machine is operating in the area.