SECTION 2 - PROCEDURES
2-32
– JLG Lift –
3120686
k. Bottom out Rear Axle Retract function.
l.
Loosen nut on rear axle retract relief and adjust
pressure to 2200 psi (152 bar). Tighten nut.
m. Lower rear end of machine.
2.17 SWING BEARING
Turntable Bearing Mounting Bolt Condition
Check
NOTE:
This check is designed to replace the existing bear-
ing bolt torque checks on JLG Lifts in service. This
check must be performed after the first 50 hours of
machine operation and every 600 hours of machine
operation thereafter. If during this check any bolts
are found to be missing or loose, replace missing or
loose bolts with new bolts and torque to the value
specified in the torque chart, after lubricating the bolt
threads with loctite #271. After replacing and
retorquing bolt or bolts recheck all existing bolts for
looseness.
Check the frame to bearing. Attach bolts as follows:
1.
Elevate the fully retracted boom to 70 degrees (full
elevation).
2.
At the positions indicated on Figure 2-15., Swing
Bearing Bolt Feeler Gauge Check, try and insert the
0.0015" feeler gauge between the bolt head and
hardened washer at the arrow indicated position.
3.
Assure that the 0.0015" feeler gauge will not pene-
trate under the bolt head to the bolt shank.
4.
Swing the turntable 90 degrees, and check some
selected bolts at the new position.
5.
Continue rotating the turntable at 90 degrees inter-
vals until a sampling of bolts have been checked in
all quadrants.
Check the turntable to bearing. Attach bolts as follows:
1.
Elevate the fully retracted boom to 70 degrees (full
elevation).
2.
At the positions indicated on Figure 2-15., Swing
Bearing Bolt Feeler Gauge Check, try and insert the
0.0015" feeler gauge between the bolt head and
hardened washer at the arrow indicated position.
3.
Lower the boom to horizontal and fully extend the
boom.
4.
At the position indicated on Figure 2-15., Swing
Bearing Bolt Feeler Gauge Check, try and insert the
0.0015" feeler gauge between the bolt head and
hardened washer at the arrow indicated position.
.0015" Feeler Gauge
Figure 2-15. Swing Bearing Bolt Feeler Gauge Check
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
