4
JL AUDIO
VR600-CSi
inStallinG the woofeRS in
faCtoRy loCationS:
If you will be using the factory speaker wires, it
may be necessary to change the terminations. This
may be accomplished by using an adaptor plug or
simply by cutting the factory connector off and
using the supplied crimp connectors to terminate
the speaker wires. The large connector is for the
positive terminal and the small connector is for the
negative terminal of each woofer. Keep in mind that
the woofer wires must be connected to the woofer
outputs of the crossovers supplied with your system
as shown in the diagram on page 2. You may also
choose to run new speaker wires...refer to the
custom installation section for details. Whichever
method you choose, observe correct polarity in
your connections. If you are unsure about any of
these issues, contact your JL AUDIO dealer for
installation assistance.
Your new speakers have been designed to install,
without modifications, into most vehicles that accept
a 6-inch (150 mm) speaker. Most factory 6-inch
speakers use four mounting screws which will line
up with the mounting holes on your woofers.
Others use a 3-hole mounting system which is
accommodated by a separate set of mounting holes
on the frames of your VR600-CWi woofers.
It is absolutely vital that the speaker frame fits
into the mounting hole cleanly. This must be
checked prior to tightening the screws. Do not
force the frame into a hole that is too small! Do
not tighten the speaker onto an uneven surface! This
will damage your speakers. The speaker should also
fit so that no air leaks around the mounting flange.
Air leaks will cause a severe degradation in sound
quality. Seal any air leaks with silicone, rope caulk or
similar sealant material.
Install as shown in the diagram here.
Use the supplied mounting clips unless the
factory holes already feature threaded inserts.
Hand-tighten the screws evenly to avoid bending
the speaker frame!
