Date: 22 January 2021
USER MANUAL | FCC ID: 2AD9E-BTM
JL Audio QCC5124 Module
FCC ID: 2AD9E-BTM
IC: 25930-BTM
FCC Part 15 Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
JL Audio, Model Number, FCC ID: 2AD9E-BTM is seeking modular approval. The radio meets
the requirements for modular approval as detailed in FCC 15.247. Compliance to each of the
requirements is described below:
1.
“The modular transmitter must have its own RF shielding.” The radio portion of the
module is contained in its own RF shielding. The shielding is installed at the factory.
Please see the Internal Photos exhibit.
2.
“The modular transmitter must have buffered modulation/data inputs.” The EUT has
buffered data inputs to insure compliance with Part 15 requirements under conditions of
excessive data rates or over-modulation. Please see the Schematics exhibit.
3.
“The modular transmitter must have its own power supply regulation.” The EUT has its
own power supply regulation to insure compliance with Part 15 requirements regardless
of the quality or level of external DC supplying the module from the host unit. Please see
Schematics exhibit. Also, the technical report exhibit contains AC power line conducted
emissions data taken with the EUT powered from a linear power supply that contains no
EMC suppression components.
4.
“The modular transmitter must comply with the ant
enna requirements of Section 15.203
and 15.204(c).” The EUT meets the FCC antenna requirements. Please see Antenna
information exhibit and internal photos exhibit.
5.
“The modular transmitter must be tested in a stand
-
alone configuration.” The EUT was
tested in a stand-alone configuration. The module was greater than 10 cm from the host
device. Please see test setup photos exhibit and technical report exhibit.
6.
“The modular transmitter must be labeled with its own FCC ID number.” The EUT is
labeled with its own FCC ID number. Please see FCC ID label & location exhibit. If the
FCC ID number will not be visible when the module is installed inside a host device,
another label with the FCC ID will be applied to the exterior of the host device.
7.
“The modul
ar transmitter must comply with any specific rule or operating requirements
applicable to the transmitter and the manufacturer must provide adequate instructions
along with the module to explain any such requirements.” The EUT is compliant with
