JK2830 Series Operation Manual Chapter 3 Introduction to [DISP]
20
———————————————————————————————————————
NOTE: When the trigger mode is set to INT, sweep test modes of SEQ and STEP
will not be controlled by [
TRIG
].
When the trigger mode is set to MAN, [
TRIG
] can be used to trigger the list sweep
test.
———————————————————————————————————————
Operation steps for setting the list sweep mode:
Set the sweep mode on the <
LIST SWEEP
> page as
SEQ
or
STEP
.
1)
On the <
LIST SWEEP
> page, move the cursor to the
SWEEP MODE
zone,
the following soft keys will be displayed:
◼
SEQ
◼
STEP
2)
Press
SEQ
to set the sweep mode as sequential sweep test mode.
3)
Press
STEP
to set the sweep mode as single step sweep test mode.
Operation steps for setting the list sweep fail mode:
Set the sweep fail mode on the <
LIST SWEEP
> page as
STOP
or
CONTINUE
.
4)
On the <
LIST SWEEP
> page, move the cursor to the
FAIL MODE
zone, the
following soft keys will be displayed:
◼
STOP
◼
CONTINUE
◼
PAUSE
◼
RETRY
3.3.2
FREQ (Hz)
This zone shows the currently swept parameter mode and its unit. What are right
below this item are parameters of the sweep list.
3.3.3
RESULT
This zone is the currently swept Function parameter and its unit. What are right
below this item are the sweep results.
3.3.4
COMP (Compare)
This zone indicates the compare results of the currently swept points. L means
the result is lower than the standard and H is higher than the standard, while
blank is medium.
