JK2830 Operation Manual Chapter 2 Introduction
9
2.5
Basic Operation
Basic operation of JK2830 is as follows:
◼
Use menu keys ([MEAS], [SET]) and soft keys to select the desired page.
◼
Use cursor keys ([
←
][
→
]) to move the cursor to the desired zone. When the
cursor moves to a specified zone, the zone will become reverse expression.
◼
The soft key functions corresponding to the current zone of the cursor will be
displayed in the soft key zone. Users can select and use the desired key.
Numeric keys, [BACKSPACE] and [ENTER] are used to input data.
When a numeric key is pressed down, the usable unit soft key will be
displayed in the soft key zone. You can choose a unit soft key or press [ENTER]
to end data inputting. When [ENTER] is used to terminate data inputting, the
unit of data will be set to a default unit, such as Hz, V or A. For example, the
default unit for frequency is Hz.
2.6
Start the instrument
Plug in 3-line power plug.
Caution: Keep the power-supply voltage and frequency conform to above
specifications. Power input phase line L, zero line N, ground line E should be the
same as that of the instrument.
Press the power switch at the left corner on the front panel and then a boot screen
will appear which displays our company logo.
If the password protection function is on, users are required to input the
password and then press [ENTER] to enter into the page of main menu.
———————————————————————————————————————
Note: The instrument has a
default password-123456
. In your practical use,
you can change it and set your own one. Please see <SYSTEM> section for more
information.
