Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
NORDIC PLUS (EN) June 2018
18
Fitting
Fitting of the finishing frame (option)
The fireplace must protrude by 10 mm with respect to the plane of the masonry to enable
the correct attachment of the frame.
A three or four-sided frame is available as an option.
The finishing frame clips onto the appliance with spring supports.
1
Place the frame on the appliance, with the back of the
frame inside the fireplace.
2
The clips are located outside the body
3
Right fitting
Wrong
fitting
Fitting of the chimney connection
Ensure the good seal of the connection. Your one face appliance is supplied with a short
stainless
steel
duct
45°
right-
angled for the
chimney
connection.
It
fits onto the
appliance.
