JHCTech KMDA-3601, User Manual

Page: 39 / 54

User’s Manual
32
3.1 BIOS Description
BIOS is the communication bridge between hardware and software. How to correctly set the BIOS
parameters is crucial for the system to work stably and whether the system works at its best.
This chapter describes how to change the system settings through the BIOS settings. For details, please
refer to the following.
Note: For the purpose of better product maintenance, the manufacture reserves the right to change the
BIOS items presented in this manual. The BIOS setup screens shown in this chapter are for reference only
and may differ from the actual BIOS. Please visit the manufacture’s website for updated manual.
You need to make SETUP settings as follows:
1. An error message appears on the screen during the system self-test and asks for the SETUP setting.
2. You want to change the factory default settings based on customer characteristics.
(But in general, customers are not recommended to set it up. In most cases, using the default value is
already the best setting.)
3.2 BIOS parameter settings
When the computer starts, the BIOS enters the power-on self-test (Post) program. The self-test program is
a series of diagnostic programs that are solidified in the BIOS. When the self-test program is executed, if
“Quiet Boot” is set to [Disabled], then the following information is displayed:
"Press <CTRL + P> to Enter MEBX setup menu" (if the motherboard supports AMT function)
"Press <DEL> or <ESC> to enter setup."
You can press <CTRL + P> during the boot process to enter the MEBX setup menu and set the AMT
related parameters.
You can also press the <DEL> or <ESC> key during the boot process to enter the setup interface and set
it up;
If this message disappears before you respond, you can turn it off and on or press the Reset button on the
chassis to restart your computer.
You can also restart your computer by pressing <Ctrl> + <Alt>+<Delete> at the same time.