BR1 User Manual
23
M-BR1-001-01
Table 5: SCPI required commands list
Command
Description
*CLS
Clears the status byte.
*ESE #
Sets the
<value>
of the Standard Event Status Enable Register.
*ESE?
Returns the value of the Standard Event Status Enable Register.
*ESR?
Returns the value of the Standard Event Status Register.
*IDN?
Returns
the instrument’s identification
(model, serial number,
firmware version).
*OPC
Sets bit 0 in the Standard Event Status Register when all pending
operations have finished.
*OPC?
Returns the ASCII character 1 when all operations have finished.
*OPT?
Returns a comma-separated list of all of the instrument options.
*RCL ”filename”
Recalls a configuration from
<filename>
.
*RST
Resets most functions to factory-defined conditions.
*SAV ”filename”
Saves configuration to
<filename>
.
*SRE #
Sets the
<value>
of the Service Request Enable Register.
*SRE?
Returns the value of the Service Request Enable Register.
*STB?
Returns the value of the status byte including the MSS.
*TST?
Initiates the internal self-test and returns the results: 0 if all tests
passed and 1 if at least one failed.
*WAI
Causes instrument to wait until all commands are completed.
Table 6: BR1 commands list
Command
Description
LASer:DISABle
Disables all lasers.
LASer:ENABle #
Turn on laser with nominal wavelength
<#>
in IL mode.
LASer:ENABle?
Returns nominal wavelength of enabled laser.
LASer:INFO?
Returns list of supported nominal laser wavelengths.
FIBer:INFO?
Returns the type of fiber (SM or MM).
READ:BR? #
Returns BR of nominal wavelength
<#>
.
REF:BR #
1
[,#
2
]
Set BR
0
for nominal wavelength
<#
1
>
(optional: assign value
<#
2
>
).
REF:BR? #
Return BR
0
value for nominal wavelength
<#>.
POW[:DET#]:INFO?
Returns serial number, calibration date, FW version, battery level,
and connection type of detector
<#>
.
POW:NUM?
Returns total number of connected power meters.
READ:POW[:DET#
1
]? #
2
Returns power read.ing of nominal wavelength
<#
2
>
(optional: specify
detector
<#
1
>
)
READ:POW:MON? #
Returns internal reference power meter reading of nominal
wavelength
<#>
.
READ:IL[:DET#
1
]? #
2
Returns IL reading of nominal wavelength
<#
2
>
(optional: specify
detector
<#
1
>
).
REF:IL[:DET#
1
] #
2
[,#
3
]
Sets IL reference on detector
<#
1
>
for nominal wavelength
<#
2
>
to
<#
3
>
or by measuring if
<#
3
>
is left blank.
