Jetter JXM-IO-E30, User Manual, Page: 45 / 70

Jetter AG Parameterization | 8
User Manual – JXM-IO-E30 45 / 70
8.2 Setting the node ID
The base node ID can be set in the System parameters [ } 47] . The default value is 0x30.
The configuration inputs (CFG1 and CFG2) generate an offset to the set base node ID.
CFG1 and CFG2 may have one of the following 3 states:
■ Jumpered to GND → Low (L)
■ Jumpered to VBAT → High (H)
■ Open → O
The offset corresponds to the values in the following table:
CFG1 CFG2 Offset of module ID
O O 0
L O 1
H O 2
O L 3
L L 4
H L 5
O H 6
L H 7
H H 8
Tab. 37: Offset for set base node ID
8.3 Diagnostic information
Diagnostic information
Index Subindex Description Type
Types of
access
Unit
0x2000 0 Number of supported entries U8 R
2 VBAT_PWR U16 R mV
3 7V IO U16 R mV
4 3V3 U16 R mV
6 PCB temperature I16 R 0.1 °C
7 CPU temperature I16 R 0.1 °C
9 CPU VRef U16 R mV
10 SPWR1 U16 R mV
11 SPWR2 U16 R mV
12 SPWR3 U16 R mV
13 VBAT_ECU U16 R mV
14 CFG1 U16 R mV
15 CFG2 U16 R mV
20 Total current ±50 % U32 R mA
Tab. 38: Diagnostic information