Jetter JVM-407B-HMI, User Manual

Page: 77 / 300

Jetter AG 77
JVM-407B Mounting and installation of the JVM-407B
Setting the IP address during runtime
The IP interface is initialized by the settings in the configuration memory
during the boot process.
The following settings can also be changed via registers to be non-remanent:
 IP address of the HMI

Subnet mask
 IP address of default gateway
The settings made during runtime do not change the parameters in the
configuration memory. At de-energizing the controller, your settings will be lost.
Register Description
104531
IP address of the HMI
104532 Subnet mask
104533 IP address of default gateway
To set the IP address and the subnet mask, proceed as follows:
Step Action
1
Enter the value 0.0.0.0 into 104533.
2 Enter the value 0.0.0.0 into 104532.
3
Enter the desired IP address of the JVM-407B into 104531.
4
Enter the desired subnet mask into register 104532.
5 Enter the desired IP address of the default gateway into 104533.
Result:
The settings are completed. Communication is possible again.
 The configuration memory (see page 75)
Introduction
Important note
Overview of registers
Setting IP addresses and
subnet mask
Related topics