Jetter JVM-407B-HMI, User Manual

Page: 271 / 300

Jetter AG 271
JVM-407B Application program
The application program is stored to the SD card or USB flash drive
When uploading the application program from JetSym to the controller, the
default storage for application programs is used.
If you want the device to read the application program from the SD card, you
have to configure the file path.
If you want to store the application program to another directory of the internal
flash disk, proceed the same way.
Since the JVM-407B's file system is case sensitive, make sure that path and
file names, as well as file entries are spelled correctly.
If you want to store the application program to the SD card or USB flash drive,
configure the device as follows:
Step Action
1
Create an application program file by JetSym.
2 Create the desired directory on the SD card or the USB stick.
3
Store the application program file to the desired directory.
4 Enter the path to the application program file and the program name into
the file \App\start.ini on the internal flash disk of the device.
Result: On re-boot, the device loads the application program from the SD
card or USB flash drive.
This file is a text file with one section holding two entries:
Element Description
[Startup] Section name
Project Path leading to the application program file
Program Name of the application program file
Example - SD Memory Card
[Startup]
Project = \SD\TestProgram
Program = Test1.es3
Example - USB flash drive
[Startup]
Project = \USB\TestProgram
Program = Test1.es3
Introduction
Prerequisites
Storing the application
program to the SD card
or the USB stick
The file \App\start.ini