Jetter JM-204-480, User Manual, Page: 92 / 126

12 Ethernet Interface (Option)
92 Jetter AG
12.3.2 The DIP switches
The switches are evaluated at starting up the JetMove 204-480...-OEM. Switches 1
through 8 influence the IP address, while switches 9 and 10 influence starting the
operating system.
Start-Up Process
After power-up the switch has no influence on the interface function. The current
position of the switch can be scanned in register 10181.
12.4 Setting the IP Address
There are four ways of assigning an IP address to a JetMove 204-480...-OEM. The
IP address that is actually being used can be read in register 2931.
12.4.1 Fixed IP address
At activating the controller, while the DIP-switches 1 to 8 are set to "OFF", the
JetMove 204-480...-OEM has got the IP-address 192.168.10.15.
If, at the other possibilities of setting, it is not clear which IP address is being used, a
definite state can be achieved by this way of "emergency setting".
12.4.2 IP address taken out of the configuration
store
At activating the JetMove 204-480...-OEM, while the DIP-switches 1 to 8 are set to
"ON", the JetControl has got the IP-address which has been stored to the
configuration memory.
Switches 9 and 10
Position Meaning
9 = OFF, 10 = OFF (NORMAL
OPERATION) Normal function of the Ethernet
interface
9 = OFF, 10 = ON (LOAD) The boot process proceeds as far as to
the initial program loader of the
Ethernet interface
9 = ON Reserved