Jetter JM-204-480, User Manual, Page: 77 / 126

JetMove 204-480 9.1 Error Messages
Jetter AG 77
9 Diagnostics
9.1 Error Messages
Note!
In the case of an error message, the letter "F" and two successive numbers
appear on the 7-segment display every second.
Error Message Table JetMove 204-480
Error
number Error type Description Response to
errors Troubleshooting
F 00 Hardware error Internal hardware
defect – Immediate
motor power
disable
– Cut drive controller from
power lines
– Return the amplifier for
repair
F 01 Internal supply
error One or more power
supply voltages are
beyond their limits. – Immediate
motor power
disable
– Cut drive controller from
power lines
– Return the amplifier for
repair
F 02 Mains phase
error Failure of one of
the mains phases. – Immediate
motor power
disable
– Check fuses and wiring
– Acknowledge the error
F 03 Motor cable
breakage The motor cable is
broken
Be careful:
The motor cable is
tested when the
drive controller is
enabled for the first
time.
– Immediate
motor power
disable
– Check the motor cable
connections
– Acknowledge the error
F 04 Overvoltage in
the DC link A DC link voltage
>850 V has been
detected. – Immediate
motor power
disable
– Check input voltage
supply.
– If the motor is used as
generator, reduce the
regenerating power.
– Acknowledge the error