Jetter JM-204-480, User Manual, Page: 30 / 126

3 Operating Conditions
30 Jetter AG
Mechanical Conditions Reference
Free falls withstanding
test Within original packing, the
device withstands dropping
over all of its edges DIN EN 50178
DIN EN 60068-2-31
Vibration resistance • 10 Hz ... 57 Hz: with an
amplitude of 0.075 mm
• 57 Hz ... 150 Hz: 1.0 g
constant acceleration
• 1 octave per minute, 10
frequency sweeps
(sinusoidal), all three
spatial axes
DIN EN 50178
DIN EN 60068-2-6
Degree of protection IP20 DIN EN 60529
Mounting position Vertical (refer to Fig. 4, page
25)
For sufficient air flow there
must be a clearance of 100
mm above and below the
device
Electrical Safety Conditions Reference
Protection class I DIN EN 50178
Dielectric strength Power to Earth and
Power to Logic DIN EN 61800-5-1
DIN EN 60146-1-1
DIN EN 60204
2.65 kV, 2 s
Insulation Power to Earth and
Power to Logic
> 1 MOhm at 500 V
Protective connection 12 V, 25 A, 0.1 Ohm DIN EN 60204
Overvoltage category III DIN EN 50178
DIN VDE 0110-1
Operating Parameters
Important!
Measures to avoid damages in transit and storage:
The packing material and the storage place are to be chosen in a way
that the values given in the above table "Operating Parameters", page
29 are met.