Jetter JM-204-480, User Manual, Page: 24 / 126

2 Installing the JetMove 204-480
24 Jetter AG
2.2 Mechanical Installation
Prior to installing the digital servo amplifier check it for possible
transport damages.
Please check the shipment for completeness.
Fix the cable strap serving as strain relief and motor cable shield next
to connector X62 (see fig. 3, page 22).
To ensure proper functioning of the JetMove 204-480 check whether
the mounting plate in the electric cabinet is unpainted.
The only possible mounting direction is vertical - see “Rear and front
view of the JetMove 204-480 enclosure with mounting holes" on
page 25.
Please make sure there is a clearance of at least 100 mm under and
above the JetMove 204-480 - unobstructed ventilation must be
ensured.
Please mark on the panel two positions for the fastening screw threads
of the JetMove 204-480 (see fig. 4, page 25).
Drill the holes and cut the thread into the panel.
Screw the corresponding fitting bolts into the thread by approximately
half of their length.
By means of the oblong holes in the rear plate, hang up the JetMove
204-480 by the fitting bolts; then screw them tightly.