Jetter JM-204-480, User Manual, Page: 108 / 126

14 Counting Input (Option)
108 Jetter AG
14.2.2 Description of connections
Specification of mating connector for X72
• 9-pin male SUB-D connector
• Metallised enclosure
EnDat cable specification
• Cable size: 2 * 2 * 0.14 mm² + 2 * 0.25 mm² (AWG 26(4) + AWG 23(2))
2 * 0.25 mm² has to be used for power supply and GND wiring.
• The cables have to be twisted in pairs and must be included in an overall
shielding.
• The following signal lines must be twisted in pairs:
DATA- and DATA+
Clock- und Clock+
0 V and voltage supply
• The shield must be connected to the connector enclosures on both ends of the
cable with the greatest possible surface area.
• Material: Copper
• Temperature class: 60 °C
• Maximum cable length: 100 m
14.2.3 EnDat cable with mating connector
HIPERFACE mating connector (solder side)
Fig. 32: EnDat mating connector of the RC series (internal thread M23)
Note!
The resolver-, HIPERFACE-, respectively EnDat mating connector of the
synchronous servo motor series JL and JK can be ordered from Jetter AG by
supplying the following particulars:
Art. no.15100069 Resolver / HIPERFACE
The complete HIPERFACE/EnDat cable between the servo amplifier series
JetMove 2xx and the synchronous servo motor series JL, JK and JH can be
ordered from Jetter AG.
It can be ordered by supplying the cable designation and the respective length in
cm:
KAY_0723-xxxx For the servo amplifier series JetMove 2xx