Jetter JetMove D203, User Manual

Page: 79 / 142

JetMove D203
Jetter AG 79
8 Status Monitoring
The amplifier LEDs indicate the operating status of the digital servo amplifier.
LEDs at JetMove D203
LED Color Status Description
VCC1 Green is lit Logic module voltage is OK
L1 Yellow is lit Axis is standing still (speed = 0)
L2 Yellow is lit A voltage of 24 V is applied to the input of
the positive limit switch (LIMIT+).
L3 Yellow is lit A voltage of 24 V is applied to the input of
the negative limit switch (LIMIT-).
VCC1
L 3 L 2
L 1
Notice!
The 7-segment display of the output stage indicates the operating and fault
conditions of the digital servo amplifier JetMove D203. The various display
modes are set by the Motion Setup. Mode 0 (default) is used for normal operation
and mode 1 for commissioning.
JetMove D203 - Seven-Segment Display
Mode 0: Normal Operation
Display Status Description
0 NOT READY TO BE
SWITCHED ON Initialization of amplifier functions
1 SWITCH-ON INHIBIT Initialization completed. Safe state. Is
achieved after initialising and after
acknowledging errors.
The drive controller can be switched
on.
2 READY TO BE SWITCHED
ON Drive controller has been disabled by
software command.
The drive controller can be switched
on.
3 SWITCHED ON DC link monitoring is activated.
4 OPERATION_ENABLED The drive controller has been
enabled.