Jetter JetMove 208-480, User Manual, Page: 39 / 124

JetMove 208-480 5.1 Electrical Specification
Jetter AG 39
Line filter Line filter ensuring EMC
in a
residential
environment to DIN EN 61800-3. The
following filters can be applied with input
circuits:
– FMAC 932-1610 with I
r
= 16 A
– FMAC 932-2510 with I
r
= 25 A
– FMAC 934-3610 with I
r
= 36 A
See "INFO 2" on page 41.
Voltage supply of processor logics
(demands on power supply module) • DC 24 V (20 ... 28.8 V)
•
≤
0.6 A
• The voltage output of the power
supply unit must comply with the SELV
or PELV type.
Inrush current limitation of the
processor logics • The JM-208-480 is equipped with a
220 µF capacitor for buffering. The
inrush current is not limited.
Internal ballast resistor • Resistor: approx. 88 .(PTC)
• Continuous output: 140 Watt
Peak output: 3 kW for 0.6 s
• Overload protection internal (warning
and error)
External ballast resistor In order to achieve greater brake power, an
external ballast resistor can be installed.
For this, see "Connection of External
Ballast Resistor and DC Link Circuit of
Another JM-208-480" on page 66.
Residual voltage To avoid hazard of electrical shock wait at
least 7 minutes after switching-off the
digital servo amplifier before attempting to
pull out the plug or remove this unit (see
page 18).
Leakage current > 3.5 mA
See "DANGER" on page 41.
Digital inputs
– Enable (E);
– Reference switch (R);
– Limit switch RH (L+);
– Limit switch LH (L-);
– Input (Inp) DC 20 V ... 28.8 V related to the ground
potential of voltage supply of processor
logics, with an input current of 7.5 mA max.
each.
See "Digital Inputs, Logic Power Supply"
on page 72.
Electrical Specifications
Ω