Jetter JetMove 208-480, User Manual, Page: 30 / 124

3 Operating Conditions
30 Jetter AG
If this storage time has been
exceeded, the device must be
connected for at least 2 hours
to the mains voltage prior to
commissioning. The motor
must remain de-energized
and the logics circuit must be
supplied with power.
The servo amplifier can then
be used again without
restriction.
Ambient temperature 0 ... 45 °C
(45 °C ... 55 °C with derating
of 2.5 % / K)
please be careful of sufficient
cooling DIN EN 50178
Air humidity 5 % - 85 %
non-condensing DIN EN 50178
Pollution degree 2 DIN EN 50178
Corrosion immunity /
Chemical resistance No special protection against
corrosion. Ambient air must
be free from higher
concentrations of acids,
alcaline solutions, salts, metal
vapours, or other corrosive or
electroconductive
contaminants. DIN EN 50178
Operating altitude Up to 1,000 m above sea level
without derating.
1,000 to 2,000 m above sea
level: Derating of 1.5 % per
100 m increase in altitude. DIN EN 50178
Mechanical Conditions Reference
Free falls withstanding
test Within original packing, the
device withstands dropping
over all of its edges DIN EN 50178
DIN EN 60068-2-31
Vibration resistance • 10 Hz ... 57 Hz: with an
amplitude of 0.075 mm
• 57 Hz ... 150 Hz: 1.0 g
constant acceleration
• 1 octave per minute, 10
frequency sweeps
(sinusoidal), all three
spatial axes
DIN EN 50178
DIN EN 60068-2-6
Degree of protection IP20 DIN EN 60529
Operating Parameters