Jetter JetMove 208-480, User Manual, Page: 24 / 124

2 Installing the JetMove 208-480
24 Jetter AG
2.2 Mechanical Installation
Prior to installing the digital servo amplifier, check it for possible
transport damages.
Please check the shipment for completeness.
Fix the cable strap serving as strain relief and motor cable shield next
to connector X62 (see fig. 3, page 21).
To ensure proper functioning of the JetMove 208-480 check whether
the mounting plate in the electric cabinet is unpainted.
The only possible mounting position is vertical - see , .
Please make sure there is a clearance of at least 100 mm under and
above the JetMove 208-480 - unobstructed ventilation must be
ensured.
Please mark on the panel two positions for the fastening screw threads
of the JetMove 208-480 (see fig. 4, page 25).
Drill the holes and cut the respective threads into the panel.
Screw the corresponding fitting bolts into the thread by approximately
half of their length.
By means of the oblong holes in the rear plate, hang up the JetMove
208-480 by the fitting bolts; then screw them tightly.