Jetter JC-120MC, User Manual

Page: 378 / 634

378 Jetter AG
10 Programming
Configuring module numbers
The module number to be entered is calculated based on the number of the
module on the system bus plus a constant value considering the system bus:
Module number = number of the system bus constant
System bus System bus constant
JX3 100
JX2 200
Module number - Printer module
This module register holds the number of the module which the display
instruction is redirected to (device # 8).
Module register properties
Values (JX3 bus) 102 ... 117
Values (JX2 bus) 202 ... 224
Takes effect Next time when STX instruction DisplayText() or
DisplayValue()
is issued
Module number - Serial interface module
This module register holds the number of the module which the display
instruction is redirected to (device # 11).
Module register properties
Values (JX3 bus) 102 ... 117
Values (JX2 bus) 202 ... 224
Takes effect Next time when STX instruction DisplayText() or
DisplayValue()
is issued
Determining module
numbers
MR 2837
MR 2838