Jetter JC-120MC, User Manual

Page: 227 / 634

Jetter AG 227
JC-120MC Programming
Command group NetCopy()
The NetCopy command is a versatile tool for data interchange between Jetter
products via Ethernet.
The NetCopy command lets you copy the following data:
 Register values
 Values of register blocks

Variable values
 Values of variable blocks
Advantages of NetCopy commands as compared with the use of network
registers:
 Within the command, you can directly specify any valid IP address.
 Within the command, you can directly specify any valid IP port.

The entire register address range of a remote node can be directly
addressed.
 By means of one command, a large register set or, in case NetCopyList is
applied, a large number of registers can be copied.

The result of the copying process can be evaluated directly.
NetCopy functions with the following nodes:
 Controllers

Bus node
 Communication modules
 PC
To access other nodes, use the NetCopy command as follows:
If ... ... then ...
... you wish to copy data from the
controller to another node,
... use the following commands:

NetCopyRegToReg

NetCopyVarToReg

NetCopyList
... you wish to copy data from another
node to the controller,
... use the following commands:

NetCopyRegFromReg

NetCopyVarFromReg

NetCopyList
For detailed information on the parameters, refer to the JetSym help.
Introduction
Advantages of NetCopy
Access via NetCopy
Parameters of the
NetCopy commands