Jetter JC-120MC, User Manual

Page: 119 / 634

Jetter AG 119
JC-120MC Mechanical and electrical installation
Interface cable JC-DK-Xm
The interface cable JC-DK-Xm lets you connect displays or HMIs to the
JC-120MC.
For information on connector specification refer to the list below:
Type 8-pin male MiniDIN connector
Manufacturer KYCON
Item KMDLA - 8P
Recommended core cross section 0.128 … 0.051 mm
2
For information on connector specification refer to the list below:
Type 15-pin male SUB-D connector in
metallized housing (quality grade 3)
Manufacturer Various manufacturers
Recommended core cross section 0.25 … 0.128 mm
2
For information on cable specification refer to the list below:
Number of cores 6
Recommended core cross section 0.14 mm
2
Maximum cable length 400 m

Complete shielding, no paired shielding
 The shield must be connected to the connector housings on both ends of
the cable with the greatest possible surface area.
Place the shield as follows:
• Connect the shield by its entire perimeter.
• Clamp it under a strain relief.
• Wrap it with copper foil.
Introduction
Male connector
specification
(controller end)
Male connector
specification (HMI end)
Specifications of
connecting cable
Cable shielding